AUMA SGM 04.1, Руководство по эксплуатации, Страница: 35 / 60

3. If the valve end position is not reached:
→
Slightly turn setting screw [2] counterclockwise until valve end position
OPEN can be correctly set.
➥ Turning the setting screw [2] clockwise decreases the swing angle.
➥ Turning the setting screw [2] counterclockwise increases the swing angle.
4. Turn setting screw [2] clockwise to the stop.
➥ This completes the setting of end stop OPEN.
5. Check O-ring in screw plug [1] and replace if damaged.
6. Fasten and tighten screw plug [1].
Having completed this procedure, the end position detection OPEN can be set
immediately.
11.2. End position detection: verify setting
1. Activate operation mode LOCAL:
→
If indication light [4] is blinking in blue: Operation mode LOCAL is
already active.
→
Indication light [4] is NOT blinking in blue: → Hold down push button
[2] for approx. 3 seconds until the indication light is blinking in blue.
➥ The actuator can be operated using the push buttons [1 – 3]:
2. Operate actuator using push buttons OPEN, STOP, CLOSE.
➥ The end position detection is set correctly if (default indication):
- the right indication light [3] is illuminated in yellow in end position CLOSED
- the left indication light [1] is illuminated in green in end position OPEN
- the indication lights go out after travelling into opposite direction.
➥
The end position detection is set incorrectly, if:
- the actuator comes to a standstill before reaching the end position
- the left indication light is blinking in red
3. If the end position setting is incorrect or not precise: <End position detection:
set again via local controls>.
11.3. End position detection: set again via local controls
Operation mode LOCAL must be activated for end position setting.
35
SGM 04.1 – SGM 14.1 / SGMR 04.1 – SGMR 14.1
Profibus DP
Commissioning (basic settings at actuator)