AUMA GP 10.1, Руководство по эксплуатации, Страница: 10 / 32

4.3.1. Input mounting flange: mount
An input mounting flange is required for mounting a multi-turn actuator. Depending
on the version, the flange for mounting the multi-turn actuator is already fitted in the
factory.
Table 3:
Suitable input mounting flanges
Input mounting flange for mounting multi-turn actuator Input shaft Reduction ratio Gearboxes
DIN 3210 EN ISO 5210 [mm]
G0 F10 20 2.4 : 1
GP 10.1 G0 F10 20 3 : 1
G0 F10 20 4 : 1
G1/2 F14 30 2.4 : 1
GP 14.1 G1/2 F14 20/30 3 : 1
G0 F10 20 4 : 1
G1/2 F14 30 4 : 1
GP 16.1
G0 F10 20 8 : 1
G1/2 F14 30 4 : 1
GP 25.1 G1/2 F14 30 8 : 1
G0 F10 20 16 : 1
G3 F16 40 4 : 1
GP 30.1 G1/2 F14 30 8 : 1
G1/2 F14 30 16 : 1
Assembly steps
1. Clean mounting faces, thoroughly degrease uncoated mounting surfaces.
Figure 7: Mounting example, input mounting flange with AUMA multi-turn actuator
[1] Gearboxes
[2] Parallel pin
[3] Input mounting flange
[4] AUMA multi-turn actuator
2. Mount parallel pin [2].
3. Place input mounting flange [3] and fasten with screws.
10
GP 10.1 – GP 30.1
Assembly