4.2
Assignment Profibus DP connection
X8 PROFIBUS
The bus signals and the galvanically isolated voltage supply for the bus
termination, as well as the bus termination resistors located on the Profibus
DP board are connected on this plug.
4.3
Assignment positioner connections
X10 AI 1
The signals required for the position transmitter potentiometer/ potentiom-
eter with RWG are connected on this plug.
16
Actuator controls AUMA MATIC AM/ AMExB/ AMExC
Profibus DP
Short instructions bus connection
Pin
Description
1
Channel 1: B cable bus termination
2
Channel 1: A cable bus termination
3
Channel 2: A cable Profibus (redundant channel)
4
Channel 2: A cable Profibus (redundant channel)
5
GND float (Profibus ground)
6
+ 5 V float (Pr 5 V)
Table 10: Assignment for plug X8
Pin
Description
1
+ 5 V for potentiometer
2
AN 1: analogue signal from position transmitter
3
GND (system ground)
4
+ 24V for RWG
Table 11: Assignment for plug X10 AI 1