Make Calls with normal Telephones and change Settings
Announcements via Loudspeaker and System Telephones
27
In order to be able to “transfer (the call partners) during a Conference“
this function must be supported via function key or via menu by the
telephone (see manual of the telephone; perhaps also called as
“ECT“ or “Transfer“).
If you use an analog telephone as an internal subscriber
telephone where the “finishing of a Conference and back to
Alternation“ is executed via T-Net function key/menu, you can also
use this comfortable operation (see manual of the telephone).
Important: In order to “finish a Conference selectively“ this function
must be supported via function key or via menu by the ISDN tele-
phones (e.g. with “Alternation“ or “single connection“; see manual of
the telephone).
InterCom Announcement and Handsfree via system telephones:
(only in combination with the system telephones COMfort 1000/1200/
2000 plus or COMfortel 1100/1500/2500/2500 AB/VoIP 2500 AB)
This function enables an announcement to system telephones (indi-
vidual telephone or group) from any available internal telephone with-
out actively taking the call at the target telephone, e.g. in a doctor’s
office.
Alternatively, you can instruct an individual system telephone to
switch on the microphone in addition to the loudspeaker (handsfree
operation) so that a person nearby can talk to you via the built-in inter-
com.
On the called system telephone the LED next to the handsfree oper-
ation/loudspeaker key flashes and the connection is established after
it rings once.
Announcement via loudspeaker: (only in combination with a door/
switch module COMmander 2TSM analog) This function enables an
announcement to a loudspeaker device or an active loudspeaker
(e.g. ELA system in a department store or supermarket) connected to
the audio output (Cinch jack marked with “audio output“) of the PBX.
A previously configured internal telephone number is called from an
internal telephone. The voice connection is established right after
dialling the telephone number.
Important: The InterCom permission must be activated on the called
system telephone.
The InterCom announcement is limited to 120 seconds. After that the
connection will be interrupted automatically unless the receiver of the
system telephone will be picked up within this period.
In case of an InterCom announcement to a group, a voice connection
will be set up even to group members not logged in. The precondition
for this is that the InterCom permission is activated on the system tel-
ephones.
Talk alternately with both Call Partners (Alternation)
k
F 2
q
Conference (see
)
Back to the previously active call partner (query)
or
F 1
o
Back to the previously hold call partner (query)
T
Announcements via Loudspeaker and System Telephones
Start an InterCom Announcement to internal System Telephones (individual Telephone or Group)
b ##011 n
g
internal telephone number*
*
Internal telephone number of the individual system telephone (If you use a direct exchange line telephone for the entry,
**
is preceding the telephone number.)
or internal telephone number of the group (If you use a direct exchange line telephone for the entry,
**
is preceding the telephone number.)
Voice connection for announcement
