Preparation
18
COMfortel WS-Base - Instructions V05 08/2017
This section describes the preparations required before commis-
sioning the device.
Wall-Mounting the COMfortel WS-Base
The WS-Base is designed to be mounted on the wall of a closed,
dry room.
Requirements
–
Tools and materials:
쐽
Drill and screwdriver
쐽
The screws and dowels included in the scope of delivery
–
Connections close to the mounting location:
쐽
Network power socket with PoE power supply
Warning:
Liquid that penetrates the casing can result in
a life-threatening electric shock or can damage or destroy
the device.
씮
Only operate the device in closed, dry rooms.
Caution:
Overheating can damage or even destroy the
device.
씮
Note the values given for ambient temperature and humidity
in the technical data.
씮
Do not expose the device to direct sunlight.
씮
Ensure that heat produced by the device can be adequately
vented into the environment. Do not install the system in a
cabinet without adequate air circulation.
Caution:
Mechanical stress can result the damage or
destruction of the device or impairment of its functions.
씮
Avoid mechanical loads (e.g. vibrations).
씮
Protect the device against dirt, excessive dust, condensation,
caustic liquids and steam.
1.
Mark holes on the wall where you intend to mount the device.
Important:
Make sure there are no electrical leads, or gas or
water pipes, in the area in which you want to drill the holes.
2.
Drill the holes (diameter 6 mm) and insert the dowels into
them.
Preparation
COMfortel_WSB_Manual_V05_08_2017_de_en.book Seite 18 Freitag, 11. August 2017 1:46 13