-5-
LCM7020PKG SYSTEM WIRING DIAGRAM
1.) Make sure the Master, and Slave monitor have been installed properly, as described in the proce-
dures as stated on page 3.
2.) Connect the four JST terminals of the System Main Cable to the corresponding JST terminals of
Master Monitor and Slave monitor on the bottom of the seats. Label the JST terminal of System
Main Cable Master and connect them to the Master monitor. The other JST terminal of System
Main cable should be labeled as Slave and conneced to the Slave monitor.
3.) There are three RCA Jacks on the other end of the System's Main Cable, labeled as Audio #1L,
Audio #1 R, Video #1. These jacks need to be connected to the respective source #1 AV plugs.
4.) The LED labeled IR repeater #1 is used to connect to AV Source #1. IR repeater #1 has an
adhesive backing that allows it to mount to the AV Source #1 Remote Sensor Eye. Remove the
backing covering the adhesive and place IR repeater #1 directly over the Remote Sensor Eye.
NOTE
: In some cases you may need to offset the LED to achieve proper operation. In the LED
cable there is a 2 pin JST terminal. Insert this terminal to AV source #1 if it has a 2 pin JST type
socket, that can accept a direct coded 38kHz signal.
5.) Repeat item three and four, for connecting AV source #2.
6.) Both sources can now be controlled with the built-in IR Repeater Circuit.
7.) The System Main Cable also gets connected to the vehicle's accessory power terminal and ve-
hicle ground.
8.) The two RCA Jacks on the system Main Cable, labeled as Audio L/Audio R are for connection the
FM Modulator.
S TOP/EJECT
AUTO
REPEAT
SENSOR
PLAY
F FWD
REW
POWER
