DISARMING THE SYSTEM (CHANNEL 1):
1. As you approach the vehicle, press and release the button on the key chain
transmitter.
WARNING!
Excessive pressure on the transmitter buttons will damage the
internal components on the circuit board. All that is required is a light push to the
button.
2. The siren will “chirp” 2 times and the vehicle's parking lamps will flash two times.
a) If the door lock interface (optional) is installed, the vehicle’s doors will
automatically unlock.
3A. ACTIVE: The dash mounted L.E.D. will turn off, and remain off until the system
is armed.
3B. PASSIVE : Never attempt to disarm the system from a distance that prevents
you from opening a door within 30 seconds. Since the system is programmed
for passive arming, it will begin to re-arm until a door is opened. Opening the
door will suspend the passive arming cycle.
INTRUSION WARNING SIGNALS:
The system will inform you if an intrusion attempt has occurred while you were away
from the vehicle. If an intrusion attempt has occurred, the siren will “chirp” 4 times
when disarming the system. Enter the vehicle and observe the dash mounted
L.E.D. for further information.
1. If the L.E.D. is flashing one time...pause... one time...etc., then an intrusion
attempt was made to a light activated entry point.
2. If the L.E.D. is flashing two times...pause...two times...etc., then an intrusion
attempt was made to the hood, trunk, or any optional sensors that were added
to the vehicle.
3. If the L.E.D. is flashing three times...pause...three times...etc., then an
intrusion attempt was made through one of the vehicles doors.
These intrusion warning indicators are stored in the system’s memory, and will only
be erased from memory when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH:
The “Valet” switch allows you to temporarily bypass all alarm functions, eliminating
the need to hand your transmitter to parking attendants or garage mechanics.
When the system is in the valet mode, all alarm functions are bypassed, however,
the remote panic feature and remote door locks (optional) will remain operational.
To use the valet mode;
1. Enter the vehicle and turn the ignition key to the “on” position.
2. Move the valet toggle switch to the “on” position. The dash mounted L.E.D. will
turn on solid, and remain on as long as the system is in the valet mode.
3. To return to normal operation, move the valet switch to the “off” position any time
the ignition is on.
In the event you lose your transmitter, or if the transmitter fails to disarm the system,
the valet switch can be used as a system override switch. Open the car door (the
alarm
WILL
sound). Turn the ignition key on, and move the valet switch to the “on”
position. The alarm will stop sounding, and the vehicle can now be started.
NOTE:
Always remember to move the Valet Switch back to the ”off” position. This
will ensure that the vehicle remains protected at all times.
Page 3
