Source mixer | MIXER
This is the mixer section, where you can adjust all sources volumes, as well as a VCA drive
parameter, allowing adjustments to the overall patch volume (if you want to balance patches
volumes, this is the parameter you need).
osc1 osc2 sub rmd nze vca
100 99 50 0 0 +6
You have access to the 2 oscillators mix level, as well as the Sub and noise level.
You can also set the rmd level, which is the level of the output of osc1 and osc2 thru a ring
modulator.
When adjusting patch volume, always compare the patch level compared to one of the factory
presets, pushing this parameter too hard (especially for polyphonic patches) may end with unwanted
nasty distortion.
Audiothingies Micromonsta user manual
14
