Audioplex SHELFTOP IR TARGET Скачать руководство пользователя страница 1

SHELFTOP IR TARGET

Used as a remote receiver and processor

SPECIFICATIONS:

INSTALLATION:

Connector:

Screw type.

Remotes:

Will handle almost all standard remote controllers (Note: does NOT work
with B & O equipment, which requires a proprietary confirmation talk-back
function).

Range:

110 feet indoors, 15 to 20 feet in direct sunlight.

Acceptance angle:

+ or - 55 degrees off center.

Wire:

Uses conventional unshielded "zip" or telephone wire.

Power:

12 VDC @ 500 mA  (unregulated, included with package)

Your ShelfTop IRTarget is designed to act as a remote receiver and processor of infrared 

signals. This sensor will receive signals from remote controllers and send these signals to a 
remote repeater. This allows remote operation of any unit from the room where the ShelfTop 
IRTarget is located. 

CAUTION: Take care to make sure that the ShelfTop IRTarget installation is NOT IN THE 

LINE OF SIGHT OR REFLECTION with the  repeater. If radiation from the repeater is picked up 
by this sensor, a feedback situation is created which will result in instability and unreliable 
operation. Undesirable reflection can occur off of light colored walls, windows, mirrors, and even 
shiny wood finishes! Also note that the wiring of the unit varies, depending on the type of infrared 
equipment that is being used (see back of this page for wiring diagrams). Please call if you have 
any questions about your installation. 

Any standard type of wire can be used. Shielded or coaxial cable is not usually required 

unless the wire passes through some unusually high electrical interference regions.

Prepare the wire leads to and from the Shelftop IRTarget by stripping about 1/4" of 

insulation from each of the ends. Twist strands tightly together so that none stick out to cause a 
possible short circuit. OBSERVE POLARITY! The sensor will not function if the wires are not in 

WARRANTY

Your AUDIOPLEX TECHNOLOGY   ShelfTop IRTarget is covered by a Lifetime warranty 

against defects in workmanship and materials. Any defects will be remedied without charge for 
labor or parts. 

Damage incurred by shipping or accident is not considered to be a defect, and not covered 

by this warranty. AUDIOPLEX TECHNOLOGY   is not responsible for defective operation caused 
by abuse or by modification or service by an unauthorized person or agency.

The unit must be properly installed and operated according to instructions for the 

warranty to apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY.   The 
products must be returned expences prepaid, with written authorization from the company. The 
unit must be shipped with the proof of purchase and in the original carton and packing material 
to avoid damage.

NOTE: The following must be specified when ordering: 1. Niles  or  Xantech  compatible 2. 40 KHz or 56 Khz.

TECHNOLOGY

INSTALL ATION MANUAL

(Patent Pending)

2000 - 9/9/02

TM

Отзывы: