The A+B-2 and A+B-2D selector switcher provides the ability to choose between two
separate sources such as a receiver or an amplifier. The unit allows the user to choose between
two separate stereo speaker pairs. This switching enables the music to be transferred to speaker
pair A in one location or speaker pair B in another location or simultaneously on both pairs in
each location. The in-wall design allows the unit to be mounted in any convenient location
between the speakers and receiver/amplifier.
WARRANTY:
Your AUDIOPLEX TECHNOLOGY A+B-2 & A+B-2D is covered by a LIFETIME
warranty against any defects in workmanship and materials. Any defects will be remedied
without charge for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by
this warranty. AUDIOPLEX TECHNOLOGY, is not responsible for defective operation caused
by abuse or by modification or service by any unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the warranty to
apply. Any necessary servicing must be done by AUDIOPLEX TECHNOLOGY. The products
must be returned expenses prepaid, with written authorization from the company. The product
must be shipped with the proof of purchase and in the original carton and packing material to
avoid damage.
A+B-2 & A+B-2D SELECTOR SWITCH
SPECIFICATIONS:
Power Rating: 5 Amps continuous
Connectors: Screw tight type, non-removable
Mounting: Fits most standard single junction boxes
Contacts: Silver cadmium
INSTALLATION:
Note that the left and the right grounds (-) are completely seperate to avoid instability
problems with amplifiers which have isolated grounds. Care should be taken that speaker
impedance should match amplifier. Any problems can be safely eliminated with our
MATCHIT(TM) or OPTIMATCH(TM) impedance correctors.
To make connection, strip about 1/4" of insulation from the wire ends, and twist the
loose strands together tightly so that no loose wire strands stick out to cause possible short
circuits! Insert the wires from the amplifier into the INPUT openings of the connector, hot to hot
and ground to ground, then tighten screws. Similarly, connect speaker wires to the control
OUTPUT openings.
TECHNOLOGY
INSTALLATION MANUAL
1999 - 4/22/99
