AudioCodes
MediaPack 1xx Analog Media Gateways
MP-124 DC-Powered Quick Guide
1
Before Installing
Congratulations on purchasing your AudioCodes MP-124 DC-Powered Analog Media Gateway! Before
you begin using the device, ensure that the following items are included in the shipped box:
Two brackets and screws for 19-inch rack mounting
DC terminal block
You’ll also need the following (not supplied):
RJ-45 Ethernet cables
PC running a Web browser
Warning:
MP-124 devices are indoor units and therefore, must be installed only indoors.
Routing of FXS telephony cables outdoors can be done only in conjunction with AudioCodes’
approved surge protector (Circa model 4B3S-75) and proper installation and grounding. When
done correctly, the installation will meet ITU-T K.21 (basic) standards. The Ethernet port
interface cabling must be routed only indoors and must not exit the building.
2
MP-124 LEDs
MP-124 provides LEDs on its front panel, as shown below and described in the subsequent table.
LED
Description
Channels
Green On: Off-hook
Red On: Line malfunction or unavailable due to
SRTP enabled
Off: On-hook
Data
Green Flash: Transmitting RTP
Red Flash: Receiving RTP
Off: No traffic
Control
Green On: Sending/receiving SIP messages
Off: No traffic
Lan
Green On: 10/100BaseTX link
Red On: Malfunction
Ready
Green On: Power on
Amber Flash: Initializing
Red On: Malfunction Off: No power
