AudioCodes Mediant 8000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 673 / 924

Version 6.6 673 October 2014
Installation & Operation Manual 41. PSTN Gateway and IP-to-IP Applications
Table 41-12: Telephone to IP / Outbound Routing Table "Destination Rules"
Parameter Name Type
Provisioning
Type
Description
Destination IP
Address String
Up to 50 chars Instant The destination IP address (in dotted
decimal notation) to where the calls will be
sent. Domain names (e.g., domain.com)
can be used instead of IP addresses.
If the Destination IP Group is defined,
leave this field empty (it will not be used
anyway).
To discard outgoing IP calls of a specific
Tel-to-IP / Outbound routing rule, enter
0.0.0.0.
Destination Port Integer
1-65535 Instant The destination IP port to where the calls
will be sent.
Transport Type Enum
NotConfigured,
UDP, TCP, TLS Instant The transport type for sending the Tel-to-
IP calls.
When set to “Not Configured”, the
Transport Type defined in SIP Proxy
Parameters is used.
Destination IP
Group Integer
1 (Not Defined) or
1-9 Instant The IP Group to where you want to route
the call. The SIP INVITE messages are
sent to the IP address(es) of the Proxy
Set that is associated with the selected IP
Group.
If you select an IP Group, it is
unnecessary to configure a destination IP
address (in the 'Dest IP Address' field).
However, if both parameters are
configured, the INVITE message is sent
only to the IP Group.
If the parameter AlwaysUseRouteTable is
enabled (in the 'IP Group' table), the
request URI host name in the INVITE
message is set to the value of the
parameter 'Dest IP Address'; otherwise, it
is set to the value of the parameter 'SIP
Group Name'.
Destination SRD Integer
0 – 31
Instant The SRD to where you wish to route the
call.
IP Profile Integer
0 (Not Defined) or
1-9 Instant The number of the Tel profile that is
assigned to the source address.