AudioCodes Mediant 8000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 645 / 924

Version 6.6 645 October 2014
Installation & Operation Manual 40. General SIP Configuration
Parameter
Name
Type
Provisioning
Type
Description
LDAP Private
NUM Attribute
Name String
Default:
msRTCSIP-
PrivateLine Instant This attribute msRTCSIP-PrivateLine
represents user private line number in
Active Directory.
LDAP Private
key String
Default:empty string Instant if the Primary Key is configured, it uses
the defined string as a primary key
instead of the one defined in
LDAPPBXNumAttributeName. It requests
the attributes which are described below.
LDAP
secondary key String
Default:empty string Instant If the primary query is not found in the
AD and the Secondary Key is configured,
it does a second query for the destination
number using a second AD attribute key
name, configured by the
LDAPSecondaryKey parameter
40.15.4 Configuring AD-Based Routing Rules
The procedure below describes how to configure Tel-to-IP routing based on LDAP
queries.

To configure LDAP-based Tel-to-IP routing for Lync Server 2010:
1.
Configure the LDAP server parameters, as described in .'Configuring LDAP
Server Parameters' on page
640 .
2.
Configure the AD attribute names used in the LDAP query.
a.
Configure the LDAP attribute names as desired.
3.
For the Gateway/IP-to-IP application: Configure AD-based Tel-to-IP routing rules:
a.
Select the relevant VoIP board, and then open the Tel to IP routing table
(
SIP GW/IP to IP Routing Telephone to IP / Outbound
).
b.
Configure query-result routing rules for each IP domain (private, PBX / IP
PBX, Lync / OCS clients, and mobile), using the LDAP keywords (case-
sensitive) for the prefix destination number:
Table 40-26: Destination Username Prefixes
AD Object Description
PRIVATE Private number
OCS Lync / OCS client number
PBX PBX / IP PBX number