AudioCodes Mediant 8000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 354 / 924

Installation & Operation Manual 354 Document # LTRT-92224
Mediant 8000
4.
Select a specific Firewall Profile entry and in the Navigation pane, select
Firewall
Rules
. The list of Firewall Rules, included in the specific Firewall Profile, is
displayed. The list is populated with default values, which enable proper
communication between the Media Gateway board and SC boards inside the
chassis; however, block any communication with other Media Gateways or
Softswitches. Additional entries should be added by the user to enable such
communication.
5.
Use the
or buttons to add or remove entries (Firewall Rules).
6.
Select a specific row and then in the configuration pane, click
Firewall Rule
Settings
; the; Firewall Rule Settings screen is displayed.
7.
Configure the Firewall Rules according to the table 'Firewall Rule Parameters'
below.

To associate the Firewall Profiles with a specific Media Gateway board:
1.
Click to access the Media Gateway status screen.
2.
Select the desired Media Gateway board.
3.
In the Actions bar, click
Lock
to stop the service on the Media Gateway board.
4.
In the Navigation pane, select
Security
and then in the configuration pane, click
Security Settings
; the Security Settings screen is displayed.
5.
Configure the
Firewall Profile
parameter to match the ID and name of the
Firewall Profile configured above.
6.
In the Actions bar, click
UnLock
to restore the service on the Media Gateway
board.
Table 33-13: Firewall Rule Parameters
Parameter Name Type Provisioning Type Description
Rule Name String
Up to 20
chars. Instant Textual, user-defined
name for the Firewall
Rule.
Use Per Subnet Enum
AllSubnets,
SpecificSub
net
Instant Defines whether this
rule applies to all
subnets or a specific
subnet.
Subnet Integer
1 – 10
Instant Defines the index of the
subnet to which this rule
applies.
This parameter is
relevant only if Use Per
Subnet == Specific
Subnet.