AudioCodes Mediant 8000, Инструкция по установке, эксплуатации и обслуживанию

Страница: 299 / 924

Version 6.6 299 October 2014
Installation & Operation Manual 32. V5.2 Access Gateway
32.1.2.5 Configuring V5.2 User Ports

The V5.2 user ports are configured via a V5.2 User Ports Configuration File. The
file contains commands that allow the addition or removal of user ports belonging
to all the V5.2 interfaces.

The configuration file is constructed by the user (typically using a text editor – e.g.
Notepad) and applied to the Mediant 8000 via the
Download V5.2 Configuration
Port File
action on the corresponding TP-8410 Media Gateway board. For
consistency, it is recommended to use .csv extension for V5.2 User Ports
configuration file.
32.1.2.5.1 V5.2 User Port Configuration File Format
The V5.2 User Port configuration file is a CSV comma separated file. Each line in the
file might be either:

The Header or Version Line - It is the first line in the file. It describes the version
number as follows:
; 1.0 version

A Comment Line - It should start with ";" and may be placed anywhere in the file,
but not before the header line.

A Command Line - A command line configures one PSTN user port or line. This
line format is as follows:
<command>,<Interface number>, <port number>,<Layer3 address>
It should comply with the following rules:

The command may be "add" or "del".

Up to 10,000 user ports may be configured on this file.

An Interface number should be in the range of 0 to 30.

A Port number should be unique within the V5.2 interface and in range between 0
and 4799.

An L3 address should be unique within the V5.2 interface and in a range between
0 and 32766.
The following is an example of a V5.2 User Ports Configuration File:
; 1.0 version
; add to V5.2 Interface 12 the port 35 with L3 address 4000
add,12,35,4000
; add to V5.2 Interface 17 the port 22 with L3 address 2345
add,17,22,2345