AudioCodes Mediant 800 MSBG, Руководство пользователя

Страница: 258 / 890

SIP User's Manual 258 Document #: LTRT-12804
Mediant 800 MSBG
4. Click OK ; the following page appears:
Figure 3-166: Defining Device Traffic Shaping
5. From the 'Tx Bandwidth' drop-down list, select the device's bandwidth transmission
rate limit. If you want to specify a TX bandwidth, see Step 8.
6. From the 'TCP Serialization' drop-down list, select whether TCP Serialization is
enabled or disabled. You can enable TCP Serialization for active voice calls only or for
all traffic. If you select 'Enable', the 'Maximum Delay' field appears for defining the
maximal allowed transmission time frame (in milliseconds) of a single packet. Any
packet that requires a longer transmission time is fragmented to smaller sections. This
avoids transmission of large, bursty packets that may cause delay or jitter for real-time
traffic such as VoIP. If you insert a delay value in milliseconds, the delay in number of
bytes is automatically updated on refresh.
7. From the 'Queue Policy' drop-down list, select the Tx traffic queueing method. This
can be based on a shaping class (Class Based) or on the pre-defined priority levels
(Strict Priority). Note that when based on shaping class, the class's bandwidth
requirements are met regardless of the priority, and only excess bandwidth is given to
traffic with a higher priority. However, when unlimited bandwidth is selected for the Tx
traffic, the queue policy can only be based on the pre-defined priority levels (i.e., Strict
Priority).
8. If you want to specify a TX bandwidth, select 'Specify' from the 'Tx Bandwidth' drop-
down list and then enter the maximum Tx bandwidth.
a. In the table, click the New Entry link; the following page appears:
Figure 3-167: Adding Tx Shaping Class