AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 568 / 1248

User's Manual 568 Document #: LTRT-10375
Mediant 500 MSBR

To enable and configure call waiting:
1. Open the Supplementary Services Settings page ( Setup menu > Signaling & Media
tab > Gateway folder > DTMF & Supplementary > Supplementary Services
Settings ).
Figure 30-10: Configuring Call Waiting
2. From the 'Enable Call Waiting' drop-down list (EnableCallWaiting), select Enable .
3. Configure call waiting indication and call waiting ringback tones in the Call Progress
Tones file (see Call Progress Tones File on page 773). You can configure up to four
call waiting indication tones (see the FirstCallWaitingToneID parameter). To configure
call waiting tones per FXS port(s) based on source or destination number, see
Configuring FXS Distinctive Ringing and Call Waiting Tones per Source/Destination
Number.
4. In the 'Number of Call Waiting Indications' field (NumberOfWaitingIndications), enter
the number of call waiting indications that can be played to the endpoint.
5. In the 'Time Between Call Waiting Indications' field (TimeBetweenWaitingIndications),
enter the time (in seconds) between consecutive call waiting indications.
6. In the 'Time Before Waiting Indications' field (TimeBeforeWaitingIndication), enter the
delay interval before a call waiting indication tone is played to the busy endpoint. This
enables the caller to hang up before disturbing the called party with call waiting
indications.
7. In the 'Waiting Beep Duration' field (WaitingBeepDuration), enter the duration (in
msec) that the call waiting indication is played to the endpoint.
8. From the 'Enable Hold' drop-down list (EnableHold), select Enable to enable call hold.
30.8 Message Waiting Indication
The device supports Message Waiting Indication (MWI) according to IETF RFC 3842. The
device also supports subscribing to an MWI server (using SIP SUBSCRIBE messages).
For FXS interfaces, the device can accept a SIP MWI NOTIFY message that indicates
waiting messages or cleared messages. Users are informed of these messages by a
stutter dial tone. You can define the stutter and confirmation tones in the CPT file. If the
MWI display is configured, the number of waiting messages is also displayed. If the MWI
lamp is configured, the phone’s lamp (on a phone that is equipped with an MWI lamp) is lit.
The device can subscribe to the MWI server per port (usually used on FXS) or per device
(used on FXO).
Note: For more information on configuring IP-based voice mail, refer to the IP Voice
Mail CPE Configuration Guide .
To configure MWI, use the following parameters:

EnableMWI

MWIServerIP, or MWISubscribeIPGroupID and ProxySet