AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 315 / 1248

Version 7.2 315 Mediant 500 MSBR
User's Manual 20. Control Network
IPv6 Interface Name
[MediaRealmExtension
_IPv6IF]
Assigns an IPv6 network interface to the Media Realm Extension.
By default, no value is defined.
Note:

The parameter is mandatory.

You must configure the Media Realm Extension with an IP network
interface that has the same IP version(s) as the Media Realm to which
the Media Realm Extension is associated. If the associated Media
Realm is assigned both an IPv4 and IPv6 network interface, you also
need to assign the Media Realm Extension with both an IPv4 and IPv6
network interface. For example, if the associated Media Realm is
assigned an IPv6 network interface, you also need to assign the Media
Realm Extension with an IPv6 network interface.
Port Range Start
[MediaRealmExtension
_PortRangeStart]
Defines the first (lower) port in the range of media UDP ports for the Media
Realm Extension.
By default, no value is defined.
Notes:

You must either configure all your Media Realms with port ranges or all
without; not some with and some without.

The available UDP port range is according to the BaseUDPport
parameter. For more information, see Configuring RTP Base UDP Port
on page 183.

Port Range End
[MediaRealmExtension
_PortRangeEnd]
Defines the last (upper) port in the range of media UDP ports for the Media
Realm Extension.
Note: It is unnecessary to configure the parameter. The device
automatically populates the parameter with a value, calculated by the
summation of the 'Number of Media Session Legs' parameter (multiplied by
the port chunk size) and the 'Port Range Start' parameter. After you have
added the Media Realm Extension row to the table, the parameter is
displayed with the calculated value.
Number Of Media
Session Legs
[MediaRealmExtension
_MediaSessionLeg]
Defines the number of media sessions for the port range. For example,
100 ports correspond to 10 media sessions, since ports are allocated in
chunks of 10.
By default, no value is defined.
Note: The parameter is mandatory.
20.2 Configuring SRDs
The SRDs table lets you configure up to 41 signaling routing domains (SRD) for Gateway
and SBC calls. The SRD is a logical representation of an entire SIP-based VoIP network
(Layer 5) consisting of groups of SIP users and servers. The SRD is associated with all the
configuration entities (e.g., SIP Interfaces and IP Groups) required for routing calls within
the network. Typically, only a
single SRD is required (recommended) for most
deployments. Multiple SRDs are only required for multi-tenant deployments, where the
physical device is "split" into multiple logical devices. For more information on multi-tenant
architecture, see Multiple SRDs for Multi-tenant Deployments on page 321.
As the device is shipped with a default SRD ("DefaultSRD" at Index 0), if your deployment
requires only one SRD, you can use the default SRD instead of creating a new one. When
only one SRD is employed and you create other related configuration entities (e.g., SIP
Interfaces), the default SRD is automatically assigned to the new configuration entity.