AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 862 / 920

User's Manual 862 Document #: LTRT-10437
Mediant 500 E-SBC
Parameter Description
on page 436 ).
Charge Codes Table
Web: Charge Codes Table
EMS: Charge Codes
CLI: configure voip > gw
analoggw ChargeCode
[ChargeCode]
This table parameter configures metering tones and their time intervals
that the E1 trunk (Euro ISDN) sends in AOC Facility messages to the
PSTN (i.e., PBX).
The format of the ini file table parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Where,

EndTime = Period (1 - 4) end time.

PulseInterval = Period (1 - 4) pulse interval.

PulsesOnAnswer = Period (1 - 4) pulses on answer.
For example:
ChargeCode 1 = 7,30,1,14,20,2,20,15,1,0,60,1;
ChargeCode 2 = 5,60,1,14,20,1,0,60,1;
ChargeCode 3 = 0,60,1;
ChargeCode 0 = 6, 3, 1, 12, 2, 1, 18, 5, 2, 0, 2, 1;
Note: To associate a configured Charge Code to an outgoing Tel-to-IP
call, use the Outbound IP Routing table.
54.10.10 Trunk Groups and Routing Parameters
The routing parameters are described in the table below.
Table 54-57: Routing Parameters
Parameter Description
Trunk Group Table
Web: Trunk Group Table
EMS: SIP Endpoints > Phones
CLI: configure voip > gw hunt-or-trunk-
group TrunkGroup
[TrunkGroup]
This table parameter configures and activates the device's
Trunk channels. This is done by defining telephone numbers
and assigning them to Trunk Groups. The format of the ini
file table parameter is as follows:
[TrunkGroup]
FORMAT TrunkGroup_Index =
TrunkGroup_TrunkGroupNum, TrunkGroup_FirstTrunkId,
TrunkGroup_FirstBChannel, TrunkGroup_LastBChannel,
TrunkGroup_FirstPhoneNumber, TrunkGroup_ProfileId,
TrunkGroup_LastTrunkId, TrunkGroup_Module;
[\TrunkGroup]
Notes:

Trunk Group ID 1 is denoted as 0 in the table.

For a description of this table, seeConfiguring Trunk
Group Table on page
353 .