AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 723 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 723 Mediant 500 E-SBC
54.3.5 HA Ping Parameters
The High Availability (HA) Ping parameters are described in the table below.
Table 54-21: HA Ping Parameters
Parameter Description
HA Device Name
configure system >
high-availability >
unit-id-name
[HAUnitIdName]
Defines a name for the device, which is displayed on the Home page to
indicate the active device.
The valid value is a string of up to 128 characters. The default value is
"Device 1" for the active device and "Device 2" for the redundant device.
HA Remote Address
configure system >
high-availability >
remote-address
[HARemoteAddress]
Defines the Maintenance interface address of the redundant device in
the HA system.
By default, no value is defined.
HA Revertive
configure system >
high-availability >
revertive-mode
[HARevertiveEnabled]
Enables HA switchover based on HA priority.

[0] Disable (default) = A switchover over to the redundant device is
done only if a failure occurs in the currently active device.

[1] Enable = A switchover over to the redundant device is done if a
failure occurs in the currently active device. However, a switchover to
the device with the highest priority (configured by the HAPriority
parameter) occurs whenever the device recovers from a failure.
Therefore, whenever possible, the highest priority device is the active
one.
For more information on the HA switchover mechansim, see Device
Switchover upon Failure on page 524.
HA Priority
configure system >
high-availability >
priority
[HAPriority]
Defines the priority of the device used in the HA Revertive mechanism.
The valid value is 1 (lowest priority) to 10 (highest priority). The default is
5.
Note:

The parameter is applicable only if you configure the 'HA Revertive'
parameter to
Enable .

You must configure each device in the HA system with different
parameter values (priorities).
HA Monitoring Parameters
Web: HA Network
Reachability
[HAPingEnabled]
Enables the pinging of an active IP network destination in HA mode to
test reachability from one of the device's IP network interfaces. If no
reply is received from a ping and the previous ping was successful, a
switchover occurs to the redundant device.

[0] Disabled (default)

[1] Enabled
Web: HA Network
Reachability Destination
Address
[HAPingDestination]
Defines the IP address of the destination that the device pings.
The default is 0.0.0.0.
Web: HA Network
Reachability Source
Interface Name
[HAPingSourceIfName]
Defines the device's IP network interface from where the ping is sent.
The valid value is the name of the IP interface as configured in the
'Interface Name' field of the Interface table. By default, no IP network is
defined.