AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 715 / 920

User's Manual 54. Configuration Parameters Reference
Version 6.8 715 Mediant 500 E-SBC
54.3 Debugging and Diagnostics Parameters
This subsection describes the device's debugging and diagnostic parameters.
54.3.1 General Parameters
The general debugging and diagnostic parameters are described in the table below.
Table 54-17: General Debugging and Diagnostic Parameters
Parameter Description
EMS: Enable Diagnostics
[EnableDiagnostics]
Determines the method for verifying correct functioning of the
different hardware components on the device. On completion of the
check and if the test fails, the device sends information on the test
results of each hardware component to the Syslog server.

[0] = (Default) Rapid and Enhanced self-test mode.

[1] = Detailed self-test mode (full test of DSPs, PCM, Switch,
LAN, PHY and Flash).

[2] = A quicker version of the Detailed self-test mode (full test of
DSPs, PCM, Switch, LAN, PHY, but partial test of Flash).
Note: For this parameter to take effect, a device reset is required.
Web: Enable LAN Watchdog
[EnableLanWatchDog] Enables the LAN watchdog feature. The LAN watchdog detects
any logical network failure.

[0] Disable (default)

[1] Enable & Reset = Enables LAN watchdog. If the device
detects a network failure, the device resets.

[2] Enable & No Reset = Enables LAN watchdog. If the device
detects a network failure, it does not undergo a reset.
The LAN watchdog periodically checks the device's overall
communication integrity by pinging the network. If the device
detects a communication failure lasting longer than three minutes,
it performs a self-test:

Test succeeds: The problem is due to a logical link failure (i.e.,
Ethernet cable disconnected on the remote switch) and the
following mechanisms are activated if enabled:

Busy Out (see the EnableBusyOut parameter)

Lifeline (see the LifeLineType parameter)

Test fails: The device resets (if this parameter is set to [2]) to
overcome the internal communication error.
Notes:

For this parameter to take effect, a device reset is required.

LAN watchdog is applicable only if the Ethernet connection is
full duplex.
Web: Delay After Reset [sec]
CLI: delay-after-reset
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by
a DHCP server.