AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 515 / 920

Version 6.8 515 Mediant 500 E-SBC
User's Manual 30. CRP Configuration
30 CRP Configuration
This section describes configuration specific to the CRP application. As CRP has similar
functionality to the SBC application, for configuration that is common to the SBC, which is
not covered in this section, see the following SBC sections:

''Configuring General Settings'' on page 471

''Configuring Admission Control'' on page 473

''Configuring Allowed Audio Coder Groups'' on page 477

''Configuring Classification Rules'' on page 480

''Configuring Message Condition Rules'' on page 486

''Configuring SBC IP-to-IP Routing Rules'' on page 487

''Configuring SIP Response Codes for Alternative Routing Reasons'' on page 497

''Configuring IP-to-IP Inbound Manipulations'' on page 502

''Configuring IP-to-IP Outbound Manipulations'' on page 505
Note: The main difference in the common configuration between the CRP and SBC
applications is the navigation menu paths to opening these Web configuration pages.
Wherever "SBC" appears in the menu path, for the CRP application it appears as
"CRP".
30.1 Enabling the CRP Application
Before you can start configuring the CRP, you must first enable the CRP application. Once
enabled, the Web interface displays the menus and parameter fields relevant to the CRP
application.
Note: The CRP feature is available only if the device is installed with a Software
License Key that includes this feature. For installing a Software License Key, see
''Software License Key'' on page
572 .

To enable the CRP application:
1. Open the Applications Enabling page ( Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling ).
2. From the 'CRP Application' drop-down list, select Enable .
3. Click Submit , and then reset the device with a burn-to-flash for your settings to take
effect.