AudioCodes Mediant 500 E-SBC, Руководство пользователя

Страница: 414 / 920

User's Manual 414 Document #: LTRT-10437
Mediant 500 E-SBC
2. Configure the parameters as required.
3. Click Submit , or click the Subscribe to MWI or Unsubscribe to MWI buttons to save
your changes and to subscribe / unsubscribe to the MWI server.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 542 .
26.1 Call Hold and Retrieve
Call Hold and Retrieve:

The party that initiates the hold is called the holding party; the other party is called the
held party.

After a successful Hold, the holding party hears a dial tone (HELD_TONE defined in
the device's Call Progress Tones file).

After a successful retrieve, the voice is connected again.

The hold and retrieve functionalities are implemented by re-INVITE messages. The IP
address 0.0.0.0 as the connection IP address or the string ‘a=inactive’ in the received
re-INVITE SDP cause the device to enter Hold state and to play the held tone
(configured in the device) to the PBX/PSTN. If the string ‘a=sendonly’ is received in
the SDP message, the device stops sending RTP packets, but continues to listen to
the incoming RTP packets. Usually, the remote party plays, in this scenario, Music on
Hold (MOH) and the device forwards the MOH to the held party.
You can also configure the device to keep a call on-hold for a user-defined time after which
the call is disconnected, using the HeldTimeout parameter.
26.2 Call Transfer
This section describes the device's support for call transfer types.
26.2.1 Consultation Call Transfer
The device supports Consultation Call Transfer. The common method to perform a
consultation transfer is described in the following example, which assumes three call
parties:

Party A = transferring

Party B = transferred

Party C = transferred to
1. A Calls B.
2. B answers.
3. A presses the hook-flash button and places B on-hold (party B hears a hold tone).
4. A dials C.
5. After A completes dialing C, A can perform the transfer by on-hooking the A phone.
6. After the transfer is complete, B and C parties are engaged in a call.
The transfer can be initiated at any of the following stages of the call between A and C:

Just after completing dialing C phone number - transfer from setup

While hearing ringback – transfer from alert

While speaking to C - transfer from active