AudioCodes Mediant 4000 SBC, Руководство пользователя

Страница: 884 / 1037

CHAPTER 57 Testing SIP Signaling Calls
Mediant 4000 SBC | User's Manual
➢
To configure played DTMF signal to answered test call:
1. Open the Test Call Settings page ( Troubleshoot menu > Troubleshoot tab > Test Call folder
> Test Call Settings ).
2. In the 'Test Call DTMF String' field, enter the DTMF string (up to 15 digits):
3. Click Apply .
Configuring Basic Test Calls
The Basic Test Call feature tests incoming calls from remote SIP (IP) endpoints to a single
simulated test endpoint on the device. The only required configuration is to assign a prefix number
(
test call ID ) to the simulated endpoint. Incoming calls with this called (destination) prefix number
are identified by the device as test calls and sent to the simulated endpoint. The figure below
displays a basic test call example:
➢
To configure basic call testing:
1. Open the Test Call Settings page ( Troubleshoot menu > Troubleshoot tab > Test Call folder
> Test Call Settings ).
2. In the 'Test Call ID' field, enter a prefix for the simulated endpoint:
For a full description of the parameter, see SIP Test Call Parameters .
3. Click Apply .
● The device can play DTMF tones to the remote endpoint. For more information, see
Configuring DTMF Tones for Test Calls .
● The Basic Test Call feature uses the default IP Group (ID #0) and its associated IP
Profile (if exists).
● Test calls are done on all SIP Interfaces.
Test Call Configuration Examples
Below are a few examples of test call configurations.
■ Single Test Call Scenario: This example describes the configuration of a simple test call
scenario that includes a single test call between a simulated test endpoint on the device and a
remote endpoint.
- 851 -