CHAPTER 51 Reporting Information to External Party
Mediant 4000 SBC | User's Manual
4.
Click
Apply
, and then reset the device with a save-to-flash for your settings to take effect.
Call Detail Records
Call Detail Records (CDR) contains vital statistic information on calls made from the device. The
device can generate and report CDRs at various stages of the call - end of call, or only at the start
and end of call. In addition, CDRs can be generated for SIP signaling and/or media. The device can
send CDRs to any of the following:
■
Syslog server. The CDR Syslog message complies with RFC 3164 and is identified by Facility
17 ("local1") and Severity 6 (Informational).
■
RADIUS server. For CDR in RADIUS format, see
. To
configure RADIUS servers for CDR reporting, see
.
●
To view SBC and Test Call CDRs stored on the device's memory, see
.
Enabling CDR Generation and Configuring the CDR Server
Address
For the device to generate CDRs, you need to enable the Syslog feature and configure a collecting
server address. The collecting server can be a dedicated CDR server or the server used for Syslog
messages.
➢
To enable CDR generation and configure the CDR server address:
1.
Enable the Syslog feature (see
).
2.
Open the Call Detail Record Settings page (
Troubleshoot
menu >
Troubleshoot
tab >
Call
Detail Record
folder >
Call Detail Record Settings
).
3.
In the 'CDR Server IP Address' [CDRSyslogServerIP] field, enter the IP address of the server
to where you want the CDRs sent.
4.
Click
Apply
.
If you do not configure an IP address for a CDR server, the device sends the CDRs to
the address that you configured for the Syslog server (see
).
Configuring CDR Filters and Report Level
You can configure various CDR filters and the stage of the call at which you want the device to
generate and send CDRs. For a detailed description of the parameters described in this section,
see
Syslog, CDR and Debug Parameters
.
➢
To configure CDR filters and report level:
1.
Open the Call Detail Record Settings page (
Troubleshoot
menu >
Troubleshoot
tab >
Call
Detail Record
folder >
Call Detail Record Settings
).
2.
Configure CDR filters:
●
In the 'Call-End CDR SIP Reasons Filter' [CallEndCDRSIPReasonsFilter] field, configure
the SIP release cause codes that if received for calls, the device does not generate and
send Call-End CDRs.
- 764 -
Содержание Mediant 4000 SBC
