CHAPTER 16 Services
Mediant 4000 SBC | User's Manual
3.
Configure the address and connection settings of the Routing server, referred to as a Remote
Web Service and HTTP remote host (see
Configuring Remote Web Services
). You must
configure the 'Type' parameter of the Remote Web Service to
Routing
, as shown in the
following example:
4.
In the IP-to-IP Routing table, configure the 'Destination Type' parameter of the routing rule to
Routing Server
(see
Configuring SBC IP-to-IP Routing Rules
):
Configuring QoS-Based Routing by Routing Server
You can configure the device to allow the routing server to route calls based on QoS metrics (media
and signaling). The device collects QoS metrics per IP Group that you have configured to operate
with the routing server ('Used by Routing Server' parameter configured to
Used
in the IP Groups
table). The metrics include the following:
■
Signaling:
ASR, NER, and ACD
■
Media:
Packet loss (Rx/Tx), packet delay (local/remote), jitter (local/remote), MOS
(local/remote), audio bandwidth (Rx/Tx), video bandwidth (Rx/Tx), and total bandwidth (Rx/Tx)
The device collects QoS metrics for both incoming call traffic and outgoing traffic from the remote
endpoint. It sends the QoS reports to the routing server, where each report can contain the status of
up to 100 IP Groups. If more than 100 IP Groups exist, the device sends multiple QoS reports
(sequentially) to the routing server. The device sends the reports every user-defined period. The
routing logic of where to route calls based on QoS ("good", "fair", and "bad") is configured on the
routing server.
For media metrics calculations, the device's License Key must include voice quality
monitoring and RTCP XR.
➢
To configure the device for QoS-based routing by routing server:
1.
Open the Web Service Settings page (
Setup
menu >
IP Network
tab >
Web Services
folder >
Web Service Settings
), and then do the following:
a.
From the 'Quality Status' [RoutingServerQualityStatus] drop-down list, select
Enable
to
enable QoS-based routing.
b.
In the 'Quality Status Rate' field (RoutingServerQualityStatusRate), enter the rate (in sec)
at which the device sends QoS reports.
- 258 -
Содержание Mediant 4000 SBC
