AudioCodes Mediant 4000 E-SBC, Конфигурационная записка

Страница: 10 / 20

Configuration Note 10 Document #: LTRT-30302
Restoring Factory Defaults
2.2 CLI Command Procedure
Once you have established CLI communication, as described in Section 2.1 , you need to
run specific CLI commands for restoring defaults. The CLI command procedure depends
on the type of device you are using.
2.2.1 MSBG Series, GW & E-SBC Series, and Mediant 4000
For the MSBG Series, Gateway & E-SBC Series, and Mediant 4000 E-SBC devices , follow
the procedure below.

To restore factory defaults:
1. At the CLI prompt, type the username (default is "Admin" - case sensitive), and then
press Enter:
# Username: Admin
2. At the prompt, type the password (default is "Admin" - case sensitive), and then press
Enter:
# Password: Admin
3. At the prompt, type the following, and then press Enter:
> enable
4. At the prompt, type the password again, and then press Enter:
# Password: Admin
5. At the prompt, type the following to reset the device to default settings, and then press
Enter:
# write factory
The CLI commands mentioned in the procedure are shown in the terminal emulation
program (HyperTerminal) below:
Figure 2-1: CLI for Resetting Device to Default (MSBG Devices)