AudioCodes Mediant 3000, Руководство пользователя

Страница: 812 / 872

User's Manual 812 Document #: LTRT-89729
Mediant 3000
Parameter Description
SIT tones)
Notes:

For this parameter to take effect, a device reset is required.

The IP-to-ISDN call is disconnected on detection of a SIT tone
only in call alert state. If the call is in connected state, the SIT
does not disconnect the call. Detection of busy or reorder tones
disconnect these calls also in call connected state.

For IP-to-CAS calls, detection of busy, reorder, or SIT tones
disconnect the call in any call state.
EMS: UDT Detector Frequency
Deviation
[UDTDetectorFrequencyDevi
ation]
Defines the deviation (in Hz) allowed for the detection of each
signal frequency.
The valid range is 1 to 50. The default is 50.
Note: For this parameter to take effect, a device reset is required.
EMS: CPT Detector Frequency
Deviation
[CPTDetectorFrequencyDevi
ation]
Defines the deviation (in Hz) allowed for the detection of each CPT
signal frequency.
The valid range is 1 to 30. The default is 10.
Note: For this parameter to take effect, a device reset is required.
53.11.9.3 Metering Tone Parameters
The metering tone parameters are described in the table below.
Metering Tone Parameters
Parameter Description
Web: Generate
Metering Tones
EMS: Metering Mode
[PayPhoneMeteringMo
de]
Determines the method used to configure the metering tones that are
generated to the Tel side.

[0] Disable = (Default) Metering tones aren't generated.

[1] Internal Table = Metering tones are generated according to the
device's Charge Code table (using the ChargeCode parameter).
Notes:

This parameter is applicable only to ISDN Euro trunks for sending
AOC Facility messages (see Advice of Charge Services for Euro
ISDN on page
397 ).

If you select 'Internal Table', you must configure the Charge Codes
table, using the ChargeCode parameter.
Charge Codes Table
[ChargeCode] This table parameter configures metering tones and their time intervals
that the E1 trunk (EuroISDN) sends in AOC Facility messages to the
PSTN (i.e., PBX).
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;