BroadCloud Hosted UC
AudioCodes Mediant CRP
46
Document #: LTRT-29836
A.3
Step 3: Configure Trunk Group Parameters
This step shows how to configure the device's channels, which includes assigning them to
Trunk Groups. A Trunk Group is a logical group of physical trunks and channels. A Trunk
Group can include multiple trunks and ranges of channels. To enable and activate the
device's channels, Trunk Groups must be configured. Channels not configured in this table
are disabled. After configuring Trunk Groups, use them to route incoming IP calls to the Tel
side, represented by a specific Trunk Group (ID). You can also use Trunk Groups for
routing Tel calls to the IP side.
A.3.1 Step 3a: Configure the BRI Trunk Group (for Devices with
BRI PSTN Interface)
This section shows how to configure the BRI Trunk Group. If your device does not have
BRI, skip this step.
To configure the BRI Trunk Group Table:
1.
Open the Trunk Group table (
Setup
menu >
Signaling & Media
tab >
Gateway
folder
>
Trunks & Groups
>
Trunk Groups
).
Figure
A-7: Configuring BRI Trunk Group Table
2.
Configure each Trunk Group as required. If more than one BRI port is available, on
line 1 of the table above, set
To Trunk
to the last BRI port to be used for PSTN
Fallback.
A.3.2 Step 3b: Configure the PRI Trunk Group (for Devices with
PRI PSTN Interface)
This section shows how to configure the PRI Trunk Group. If your device does not have
PRI, skip this step.
To configure the PRI Trunk Group Table:
1.
Open the Trunk Group table (
Setup
menu >
Signaling & Media
tab >
Gateway
folder
>
Trunks & Groups
>
Trunk Groups
).
Figure
A-8: Configuring PRI Trunk Group Table
2.
Configure each Trunk Group as required. If more than one PRI port is available, on
line 1 of the table above, set 'To Trunk' to the last PRI port (2) to be used PSTN
Fallback.
