AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 613 / 650

Version 6.6 613 MP-11x & MP-124
User's Manual 44. Configuration Parameters Reference
Parameter Description
Charge Codes Table
Web: Charge Codes Table
EMS: Charge Codes
[ChargeCode]
This table parameter configures metering tones and their time
intervals that the FXS interface generates to the Tel side.
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1,
ChargeCode_PulsesOnAnswer1, ChargeCode_EndTime2,
ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3,
ChargeCode_PulsesOnAnswer3, ChargeCode_EndTime4,
ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Where,

EndTime = Period (1 - 4) end time.

PulseInterval = Period (1 - 4) pulse interval.

PulsesOnAnswer = Period (1 - 4) pulses on answer.
For example:
ChargeCode 1 = 7,30,1,14,20,2,20,15,1,0,60,1;
ChargeCode 2 = 5,60,1,14,20,1,0,60,1;
ChargeCode 3 = 0,60,1;
ChargeCode 0 = 6, 3, 1, 12, 2, 1, 18, 5, 2, 0, 2, 1;
Notes:

This parameter is applicable only to FXS interfaces.

To associate a configured Charge Code to an outgoing Tel-
to-IP call, use the Tel to IP Routing.

To configure the Charge Codes table using the Web
interface, see Configuring Charge Codes Table on page
302 .
44.11.8 Telephone Keypad Sequence Parameters
The telephony keypad sequence parameters are described in the table below.
Table 44-57: Telephone Keypad Sequence Parameters
Parameter Description
Web/EMS: Call Pickup Key
[KeyCallPickup]
Defines the keying sequence for performing a call pick-up. Call
pick-up allows the FXS endpoint to answer another telephone's
incoming call by pressing this user-defined sequence of digits.
When the user dials these digits (e.g., #77), the incoming call
from another phone is forwarded to the user's phone.
The valid value is a string of up to 15 characters (0-9, #, and *).
The default is undefined.
Notes:

Call pick-up is configured only for FXS endpoints pertaining
to the same Hunt Group.

This parameter is applicable only to FXS interfaces.