AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 464 / 650

User's Manual 464 Document #: LTRT-65432
MP-11x & MP-124
Parameter Description
Test Duration
[Test_Call_TestDur
ation]
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Note: This parameter is applicable only if 'Call Party' is set to Caller .
Play
[Test_Call_Play]
Enables playing a user-defined DTMF signal to the answered side of the
call.

[0] Disable (default)

[1] DTMF
To configure the played DTMF signal, see 'Configuring DTMF Tones for
Test Calls' on page
466 .
Notes:

To configure the DTMF signaling type (e.g., out-of-band or in-band) use
the 'DTMF Transport Type' parameter (see 'Configuring DTMF Transport
Types' on page
181 ).

This parameter is applicable only if 'Call Party' is set to Caller .
Schedule Interval
[Test_Call_Schedul
eInterval]
Defines the interval (in minutes) between automatic outgoing test calls.
The valid value range is 0 to 100000. The default is 0 (i.e., scheduling is
disabled).
Note: This parameter is applicable only if 'Call Party' is set to Caller .
42.1.1 Starting, Stopping and Restarting Test Calls
The procedure below describes how to start, stop, and restart test calls.

To start, stop, and restart a test call:
1. In the Test Call table, select the required test call entry; the Actions button appears
above the table.
2. From the Actions drop-down list, choose the required command:
•
Dial : starts the test call (this action is applicable only if the test call party is the
caller).
•
Drop Call : stops the test call.
•
Restart : ends all established calls and then starts the test call session again.
The status of the test call is displayed in the 'Test Status' field of the Test Call table:

"Idle": test call is not active.

"Scheduled": test call is planned to run (according to 'Schedule Interval' parameter
settings)

"Running": test call has been started (i.e., the Dial command was clicked)

"Receiving": test call has been automatically activated by calls received for the test
call endpoint from the remote endpoint (when all these calls end, the status returns to
"Idle")

"Terminating": test call is in the process of terminating the currently established calls
(this occurs if the
Drop Call command is clicked to stop the test)

"Done": test call has been successfully completed (or was prematurely stopped by
clicking the
Drop Call command)
A more detailed description of this field is displayed below the table when you click the
Show/Hide button (see 'Viewing Test Call Statistics' on page 465 .