1. Getting Started with Initial Connectivity
M500Li Analog VoIP Gateway
- 7 -
1.3.2
Configuring the WAN Interface
This procedure describes how to configure the WAN interface and uses Gigabit Ethernet.
Before configuring the WAN interface, make sure that you have all the required
information from your Internet Telephony Service Provider (ITSP)
To configure a WAN IP address:
1.
Connect the WAN port to the WAN network.
For information on cabling the WAN port, refer to the Hardware Installation Manual.
2.
Open the WAN Interface page (
Setup
menu >
IP NETWORK
tab >
CORE ENTITIES
folder >
WAN Interface
).
3.
In this page you can set:
•
WAN SETTINGS (Static or DHCP Client - Default WAN interface is DHCP Client)
•
DNS SETTINGS (Static or Auto - Default DNS settings is Auto)
1.3.3
Remote Web-based (HTTP/S) Management
To enable remote Web-based management (HTTP/S) from the WAN:
1.
Open the WEB Settings page (
Setup
menu >
Administration
tab >
Web & CLI
folder >
WEB
Settings
).
2.
Allow WAN access:
•
For
HTTP
: From the 'Allow WAN access to HTTP' drop-down list, select
Enable
.
•
For
HTTPS
: From the 'Allow WAN access to HTTPS' drop-down list, select
Enable
.
3.
Click
Apply
and save to flash.
Содержание M500Li
Страница 2: ......