6mm Hex Key
(1)
M8 X20 M8 NUT
(4)
(4)
Attach the bracket in the desired position and
location using the 4 nuts and bolts provided.
Hand tighten the nut till its snug.
Place codec to confirm cable clearance before
tightening completely.
HDCB Clamp
(1)
HDCB Bracket
(1)
Plastic Spacer
(2)
10-32 Nut
(2)
10-32 Washers
(2)
3mm Washers
(2)
AUDIO VISUAL FURNITURE INTERNATIONAL
288 Don Hillock Drive, Aurora, Ontario L4G 0G9 www.video-furn.com
Toll Free: 1-877-834-3876 Fax: 1-905-751-1488 Local: 905-751-1459
Note:
If you cannot understand these instructions or are concerned about safety of the installation
Contact a qualified contractor or contact
A
VFI at 1-877-834-3876.
Confirm all hardware is included before you begin assembly.
Not all hardware supplied will be used depending on the manufacturer of your display/s.
PM-HDCB
M
ounting Instructions
Thank you for purchasing
A
VFI's High Definition Codec Bracket.
This product was designed for mounting a single HD Codec
to
AVFI
PM-
S-
FL,
PM-
X
F
L
-
D
& PM-XFL-S
display stands
o
r for
mounting on to/into a wooden or MDF cart
or a
wall
.
Supplied Parts:
Supplied Hardware:
Page 1
of 2
Hardware Bag
(1)
rev 2.0
OR
The Lifesize codec only requires a single piece mount.
If Using Polycom or Tandberg Codec, assemble the two
pieces using the 10-32 nuts with washers.
You want the two pieces to adjust later, so don't tighten
the nuts.
