VCP-010-06(-07)-x Installation & Operation Manual
Document # 540236, Rev IR, 11/2002
Page 8 of 21
SECTION II - INSTALLATION
1.0 Prior to Installation
1.1
During the design and layout of the aircraft cabin, careful consideration of
the location of this and all other audio/visual modules is necessary. Some
of the items to be considered include:
•
Space
•
Proximity to other devices (i.e. source equipment)
•
Available power supply
•
Length of cable runs
•
Environmental conditions (temperature, humidity, etc.)
•
Location of other aircraft systems (i.e. oxygen delivery)
•
Access for service repair (if applicable)
•
Convenience for user interface
1.2 The VCP-010-06(-07)-x shall be installed to conform to the standards
designated by the customer, installing agency, and existing conditions as
to the unit location and type of installation.
1.3
Mounting screws are required to secure the unit. Refer to Section II, 9.0
for mounting hole diameters and configurations.
1.4
All headphone amplifiers and line level amplifiers shall be located no more
than three (3) feet away from the VCP-010-06(-07)-x. Long low-level
audio runs may introduce noise into the audio signal.
1.5
The VCP-010-06(-07)-x must be mounted in a horizontal position (not on
its side or back).
1.6
Temperature consideration of the installation area is important. Operating
temperature range for the unit shall be between -15° and +55° Celsius.
1.7 Avoid installing the unit where it will be exposed to excessive heat,
moisture, splashing liquids, dusty areas, or direct sunlight.
2.0 Unpacking and Inspection
2.1
Carefully open the packaging and remove the VCP-010-06(-07)-x. Verify
that all components have been included in the package per the packing
list. Inspect the unit for shipping damage.
