EN-650W-01-x Installation Manual
Document # 540246, Rev IR, 05/2002
Page 5 of 10
3.2
Unpacking and Inspection
3.2.1 Carefully open the packaging and remove the speaker. Verify that
all components have been included in the package per the packing
list. Inspect the unit for shipping damage.
3.2.2 If damage has occurred during shipping, a claim should be filed
with Audio International WITHIN 24 hours and a
Return Request
Authorization Number
shall be obtained from AI. Refer to the
front cover of this manual for address and telephone number of
Audio International, Inc. Repackage the unit in its original
packaging materials and return it to AI following instructions given
by the AI representative. If no return is necessary, retain the
packing list and the packing materials for storage.
3.3
Cautions and Warnings
3.3.1 It is important to do a pin-to-pin power and ground check on all
connectors. Ensure that power and ground are applied only where
specified. Damage to the unit may result if power or ground is
applied to the wrong points.
3.3.2
DO NOT
remove any factory-installed screws. Damage to the unit
may result and void any warranties.
3.3.3
DO NOT
install near heat sources such as direct sunlight, warm air
exhausts, or heaters.
3.3.4
No
scheduled maintenance is required to ensure continued
airworthiness.
3.3.5
ESD
(Electro Static Discharge) guidelines shall be followed.
