AI-HUB-03-x Installation Manual
Document # 540316, Rev IR, 03/2006
Page 9 of 12
3.7 Mating Connector Information
All wiring harnesses to the unit shall be supplied and fabricated by the
installing agency.
Model #
Pin #
Mating Connector
P1 – P8
943-SP-37-08-08-S Stewart
AI-HUB-03-1
P9 RD9F10JVL0
P1 – P8
943-SP-37-08-08-S Stewart
AI-HUB-03-2
P9
DEMA-9S
DE24657 Backshell
D20418-2 Female Screw Locks
3.8
Pinout Assignment and Descriptions
P9
Pin #
Signal Name
1
+28 VDC Power Input
2 Ground
3 N/C
4 N/C
5 N/C
6 N/C
7 N/C
8 N/C
9 N/C
3.9 Post-Installation
Test
When power has been applied to the unit, the green Pwr (Power) LED on
the front panel is on, and the green Link LED on each connected port is
on. When the switch is connected and operating, refer to Section 2.1,
Introduction, for the LEDs and their activity.
4.0 Instructions for Continued Airworthiness
4.1 Airworthiness Limitations
No
periodic scheduled maintenance or calibration is required for continued
airworthiness of the AI-Hub-03-x.
If the unit fails to perform to
specifications, it must be removed and serviced by a qualified service
facility.
