Getting Started
1) Carefully remove your new Adept Response power conditioner from the
shipping carton. Next inspect it for shipping damage.
2) Mount or place the unit in its proper working position. Make sure there is
sufficient room to access the power outlet receptacles so that you can make
good connections.
3) With the rear panel circuit breaker in the off (down) position, attach the power
cord.
4) Plug the power cord into the wall.
5) With all components turned off, plug them into the Adept Response. Start with
the receptacle nearest to the incoming power line with the power amps, follow
with the preamp then plug in all the front end pieces. D/A converters and other
digital components should be plugged in farthest from the power entry point.
6) Carefully slide the unit into place, not putting excessive force on the isolation
feet. Check to make sure all the plugs are securely in place.
7) Turn your Adept Response on first, and then your components starting with
your sources first ending with amplifiers last, so that the components built- in soft
start and protection circuitries can react effectively.
8) ENJOY!
9) Reverse the process to remove the Adept Response.
10) When removing the Adept Response, remember to always turn off amplifiers
first.
