Audi Q5 2008, Руководство по ремонту

Страница: 24 / 197

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.3 Overview - Selector Lever Cable
1 - Bolt
❑ 13 Nm
❑ For selector lever cable
adjustment
❑ Attached to the selector
mechanism function
unit
2 - O-ring
❑ Always replace
3 - Clip
❑ For the selector lever
cable on the selector
mechanism function
unit
4 - Bolt
❑ 8 Nm
❑ Quantity: 2
5 - Selector Lever Cable
Bracket
6 - Clip
❑ For connecting the se‐
lector lever cable to the
selector lever cable
bracket
7 - Selector Lever Cable
❑ Depending on the ver‐
sion with heat shield.
Refer to
⇒ Fig. ““Selector Lever
Cable Heat Shield -
Tightening Specifica‐
tion”“ , page 21 .
❑ Do not bend
❑ Removing and installing. Refer to
⇒ “1.10 Selector Lever Cable, Removing and Installing”, page 43
❑ The selector lever cable must be replaced if the rubber grommet is damaged.
❑ Lubricate the ball socket lightly with Polycarbamide Grease - G 052 142 A2- before installing.
❑ Make sure the rubber grommet on the transmission side is not twisted when installing.
❑ Adjusting. Refer to
⇒ “1.11 Selector Lever Cable, Checking and Adjusting”, page 47
8 - Selector Lever
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
20
Rep. Gr.37 - Controls, Housing