Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Loosen all three bolts -arrows-, but do not remove.
Caution
The ATF cooler can be damaged my ATF lines installed under
stress.
♦ By loosening the bolts tension is created in the ATF lines.
– Re-tighten the bolts -arrows- to the tightening specification.
• Tightening specifications. Refer to
Note
Replace the O-rings.
– Install the subframe crossbrace. Refer to ⇒ Suspension,
Wheels, Steering; Rep. Gr. 40 ; Subframe; Overview - Sub‐
frame .
– Check the ATF level. Refer to
7.3
ATF Filter, Removing and Installing
Special tools and workshop equipment required
♦ Used Oil Collection and Extraction Unit - VAG1782-
Removing
Note
♦
Clean working conditions for the automatic transmission. Re‐
fer to
⇒ “3.1 Clean Working Conditions, Guidelines”, page 5
♦
General repair instructions. Refer to
⇒ “3.3 General Repair Information”, page 6
– Remove the ATF oil pan. Refer to
⇒ “1.1 Transmission Fluid Pan, Removing and Installing”,
.
– Place the -SMN372500- under the transmission.
– Carefully pull the ATF filter downward and off the Mechatronic.
Installing
Install in reverse order of removal. Note the following:
– Mount the O-ring -2- on the ATF filter -1-.
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
7. ATF Circuit
125
