Audi A8 2010, Руководство по обслуживанию

Страница: 92 / 142

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Puller - T40039-
♦ Torque wrench - VAS 6583- , measuring range 3 to 60 Nm
Table of tightening torques for installation:
Component/fastener [Nm]
Spark plugs 30
Securing bolts for connector rail 5
Removal steps:
– Remove engine cover panel
⇒ page 15 .
Step 1 - removing spark plugs, cylinder bank (right-side):
– Move fuel line -1- and hose -2- leading to activated charcoal
filter clear at air pipe.
– Pull vacuum hose -3- off air pipe.
– Loosen hose clips -arrows- and detach air pipe.
– Unscrew bolts -arrows- for connector rail.
– Release connectors for ignition coils and unplug all connectors
from ignition coils at the same time.
– Place connector rail slightly to one side. Make sure that wiring
is not kinked or damaged.
Audi A8 2010 ➤
Maintenance - Edition 11.2014
88
3. Maintenance