INSTALLATION MANUAL
NELO706V SERIES SURFACE MOUNT SPEAKERS
STEP 1
STEP 2
The NELO706V series speakers are delivered assembled.
For installation, both parts (speaker part and wall part) needs to be
taken apart. This is done through releasing both screws (top and
bottom) of the speaker, and removing both parts from each other.
The wall part has to be assembled to the provided location on the
wall or ceiling. This is done through knocking out the provided areas
(teardrop holes) for the fasteners. Choose the fasteners depending on
the mounting surface (concrete, wooden, steel, ...) The distance between
both mounting positions is 130 mm.
Also make sure the connection cables are provided through the
designated openings (grommets) for connecting the speaker accordingly.
STEP 3
Connect the wires coming from the amplifier to the SnapConnect™ on
the rear speaker part.
The correct power tapping is chosen by connecting the appropriate
terminals of the connector. A description of the power tap selection
is shown on the magnet sticker on the rear side of the loudspeaker.
NELO706V:
•
White: 833 Ω - 70V/6W
•
Red: 1667 Ω - 100V/6W - 70V/3W
•
Blue: 3333 Ω - 100V/3W - 70V/1.5W
• Black: COM
STEP 4
Assemble both speaker and wall part again through joining both parts
together. Make sure the speaker part is in the right direction to make
sure it can easily slide into position. Once positioned, insert both screws
again to tighten both parts together.
The speaker is now ready for use.
STEP 5
The NELO706V includes two knobs for volume adjustment. The
protruding knob is assembled by default and allows easy adjustment
by hand. This is recommended for frequent volume changes. A second
flush knob with screwdriver notch is included and recommended
for permanent settings, or when rare and non user configurable
adjustments are required.
The included knobs can be exchanged and easily replaced by just
pulling from the shaft and assembling (by pressing) the replacement
part on this position.
