FLEXNET – FNER Expandable (Modular) Routing Switches – Installation & Operation Manual
7-3
CHAPTER 7: FACTORY CONFIGURATION SETTINGS
Figure 25: Matrix Size
7.6 Model
Option 2 of the System Setup menu will load the Model Number/Type screen of Figure 26. This option is included as part of
the system’s firmware identification in accordance with the protocol outlined in Appendix D. The control system is not affected
by the model number or type. System expansion requires no change of the model number.
To get to the Model Number/Type screen from the main menu: key sequence 2, 1, (factory settings code F1), 1, 2
2. System Options
1. Configuration (factory settings code F1)
1. System Setup
2.
Model
Figure 26: Model Number/Type
7.6.1 Module Sizes Menu
Option 3 of the System Setup menu will load the Module Sizes Menu of Figure 27. This menu allows you to select option 1 -
SRR size or option 2 - SRO size. From this menu, press 1 to specify the number of inputs per SRR switching module. Press
2 to specify the number of input rows per SRO.
To get to the Module Sizes Menu from the main menu: key sequence 2, 1, (factory settings code F1), 1, 3
2. System Options
1. Configuration (factory settings code F1)
1. System Setup
3. Module Sizes
Figure 27: Module Sizes Menu
7.6.2 SRR Module Size
Option 1 of the Module Size Menu will load the SRR Module Size Screen of Figure 28. The standard size of an SRR is 16
inputs by 1 output, although sizes less than that can be special ordered. The maximum size that can be specified is 16 inputs
by 1 output. This setting should never be changed unless the system is being upgraded.
To get to the SRR Module Size screen from the main menu: key sequence 2, 1, (factory settings code F1), 1, 3, 1
2. System Options
1. Configuration (factory settings code F1)
1. System Setup
3.
Module
Sizes
1.
SRR
Module
Size
