QSP-860MPX: Instructions for Basic Operation and Installation
Page 4
G
ETTING
S
TARTED
The above diagram shows the typical 8-camera installation for the QSP-860MPX. Up to eight cameras
can be connected to the multiplexer using the back panel connectors. Note that the VCR and monitor
connections must be as shown above for proper operation.
Installation Steps
The following steps should be followed to ensure proper connection and set up of your QSP-860MPX.
A diagram showing the overall connection configuration of the QSP-860MPX is shown above.
The installation steps are:
1.
Connect your cameras, monitor, and VCR to the QSP-860MPX as shown above. Refer
to the “Back Panel Connections” and “Video Termination Switches” sections on the next
page for proper connections and switch settings for your particular installation.
2.
Power up the QSP-860MPX and enter the QSP-860MPX set up menus by pressing and
holding the DISPLAY button for approximately 3 seconds. Refer to the Set Up Menus
section of the manual starting on page 7.
3.
Set the current time and date in the QSP-860MPX using the “Time/Date Set” menu.
Alarm Inputs
Camera
Camera
Camera
10K
(Optional)
Alarm Out
QSP-860MPX
Configuration
VIDEO OUT
VCR-IN
Camera
Camera
Camera
Camera
Camera
VCR OUT
VCR
OUT
IN
Optional for alarm
or VCR activated
recording
Monitor
Cam Switch
Signal