QSP-860MPX: Instructions for Basic Operation and Installation
Page 10
many frames as medium priority cameras. “Alarm Only” cameras are not recorded unless there is an
alarm input and a live video signal is present. “Alarm Only” cameras, under alarm conditions, will be
multiplexed like any other alarm camera. Dead or non-existent cameras will not be recorded.
Cameras under alarm conditions have a higher priority than “High Priority” cameras and will be given
twice as many frames. Even under multiple alarm conditions, all cameras are guaranteed some VCR
frames. Multiplexing of alarmed cameras cannot be disabled without disabling the alarm input itself
(which will prevent both monitor and VCR alarm activity). In the above example, if the alarm for “Alarm
Only” camera #8 were triggered, the multiplexing order would be:
8,1,8,2,8,3,8,5,8,1,8,2,8,4,8,1,8,2,8,3,8,6,8,1,8,2,8,4,8,1,8,2,8,3,8,5,8,1,8,2,8,4,8,1,8,2,8,3,8,6....
Camera Monitor Disable
This menu allows an individual camera to be eliminated
from the monitor live mode display while the camera
continues to be recorded (multiplexed). A “Record Only”
camera is replaced by the “bar pattern” in live display
modes except during an alarm condition where the
camera’s video is shown. A “Record Only” camera’s
video is still multiplexed.
Selecting:
1 - 8
Toggles the camera’s live display from
“Display on Monitor” to “Record Only”.
The default is “Display on Monitor”.
In the example shown, Camera 8 is set to “Record Only”
and it’s image will be replaced by the “bar pattern” in live
displays. Also note that the presence of the camera signal is still detected on any camera set to
“Record Only”. The “No Video” indication will be given on the live display along with the “bar pattern” if
the camera’s signal is not present.
Display Sequence Set Up
The QSP-860MPX has a programmable display sequence format for display modes that support
sequencing. The image hold (dwell) time is also programmable.
Dwell Adjustment
Selecting:
1
Selects the dwell time for edit.
While editing:
1 - 8
Used to enter digits “1” through “8”.
PIP
Used for a “0” entry.
QUADRANT
Used for a “9” entry.
DISPLAY
Completes the entry if less than 3 digits
and returns to the previous value if no
digits are entered.
Display Sequence Set Up
1: Hold Each Image
for: 3 Sec.
2: Full Camera Call Up . . .
3: Quad . . .
4: PIP . . .
5: Dual PIP . . .
6: Split/Squish Screen . . .
PIP: Restore Default Settings
Camera: Select/Change
DISPLAY: Previous Menu
Monitor Disable
1: Display on Monitor
2: Display on Monitor
3: Display on Monitor
4: Display on Monitor
5: Display on Monitor
6: Display on Monitor
7: Display on Monitor
8: Record Only
Camera: Select/Change
DISPLAY: Previous Menu