ATS SuperTrak GEN3, Руководство по эксплуатации и обслуживанию, Страница: 19 / 366

Safety Information
SuperTrak™ GEN3 System Operation and Maintenance Manual 7
Rev. 9 (12-2021)
• Do not install substitute parts or make any product modifications that are not
authorized by ATS because this may introduce new hazards.
• Use insulated tools when working with electrical equipment. Make sure qualified
electrical technicians wear appropriate PPE when completing live electrical work
according to the hazard assessment.
• Remove electrical power before changing fuses, or use approved fuse-pullers.
• Never use jumper wires or fuse substitutes to replace fuses.
• Replace the line fuses with fuses of the same voltage, current rating, and type.
Do not use repaired fuses or short-circuited fuse holders.
• Be prepared to handle electrical fires by keeping dry powder or carbon dioxide
extinguishers on hand at all times.
• Verify that all fittings and connections are tight once repair work is complete.
• Do not use compressed air to clean SuperTrak conveyance platform devices.
Use clean, lint-free cloths or a vacuum cleaner. Compressed air causes dirt and
lubricants to become airborne and contaminate assembly products and tooling.
Personal Protective Equipment
At a minimum, all users are recommended to wear the following personal
protective equipment (PPE) when working with or around the SuperTrak
conveyance platform:
• Safety glasses that meet the specific standard requirements the local
jurisdiction:
• North America - ANSI Z87.1
• Europe - EN 166 F
• Safety shoes that meet the specific standard requirements the local
jurisdiction:
• North America - ASTM F2413
• Europe - EN ISO 20345 S1