ATS Maximus MCJ2000 Series, Справочное руководство, Страница: 111 / 214

Chapter 3: Monochrome Terminals Test Mode
MANU-MAXIMUS-02 Maximus Reference Manual 3-57
Revision-02
RTC Test
The RTC test checks the functionality of the Real Time Clock and beeps every second while
flashing the “OK” LED during the test. Use the following procedure to run the RTC test:
1. In the Test Mode menu, press the clear key until the RTC Test option appears.
2. Press the enter key to start the RTC test. The terminal displays the RTC for the
hardware and software and flashes the “OK” LED and beeps every second.
3. When you are finished press the clear key to stop the test and exit to the Test
Mode menu (at the DIDO Test 1 option).
GSM Signal Strength
This option only appears with a GSM / GPRS module installed and used primarily when
installing a 5-meter antenna (see
"GSM Long Cable Antenna" on page 2-14 ).
The test displays the signal strength of the cellular data network received by the GSM antenna.
Move the terminal, antenna, or both to change the received signal strength. You need a signal
strength of at least 15 for a GSM/GPRS terminal. Press the
clear key to exit when finished.
Test Mode
RTC Test
HW 05/06/13 09:14:47
SW 05/06/13 09:14:47
This test will disconnect the terminal from the GSM/GPRS network for the duration of the
test.
NOTE:
Signal strength measures from 0 to 32 with 15 or higher being best.
NOTE: