ATS Co-Pilot, Руководство по установке

Страница: 8 / 12

Locate the Red wire coming from the vehicle’s PCM Pin # 71. Tap this wire with the red
Co-Pilot wire by soldering. Shield the tap from the elements.
Black Wire- Ground (GND) – PIN #9
Locate the Black wire coming from the vehicle’s PCM Pin # 51 . Tap this wire with the black
Co-Pilot wire by soldering. Shield the tap from the elements.
Yellow Wire– PCM - PIN #10 and Blue Wire– TCC - PIN #11
Locate the vehicle’s Torque Converter Clutch (TCC) wire coming from the vehicle’s PCM to the
transmission. This Purple w/ Yellow stripe wire can be found at the PCM at pin # 28 . Cut this
wire and solder, or attach a butt connector to the wire leading back to the transmission and attach
a butt connector to the wire heading to the vehicles computer (PCM). Reference the supplied
wiring schematic before cutting wire.
Connect the Yellow wire coming from the Co-Pilot to the wire that goes to the PCM. Connect
the Blue wire coming from the Co-Pilot to the wire that goes to the transmission.
Protect the connections from the elements.
Green Wire- Vehicle Speed Sensor (VSS) – PIN #17
Locate the VSS (Vehicle Speed Sensor) wire. This Gray w/ Black stripe wire can be found at
the PCM at pin # 58 Run the green wire from the Co-Pilot module to the VSS wire and cut off
any excess, but leave some slack. Solder the Green Co-Pilot wire to the VSS wire and protect
from elements, this is the most common install problem with wiring