ATS 2140-M Series, Инструкция по эксплуатации, Страница: 17 / 115

17
3.5 Hardware Installation
All hardware is built at the ATS factory. If hardware installation is required on site, please contact the
Service Department. ONLY PERFORM THOSE OPERATIONS THAT APPLY TO THE UNIT RECEIVED.
NOTE: ELECTRICAL POWER MUST BE CONNECTED PRIOR TO ARRIVAL OF ATS SERVICE.
3.5.1 Lever Arm Assembly Installation
1. Position the knife-edge support block assembly on top of the test frame so that the serial
number on the block is facing the weights.
2. Install the locating dowels.
3. Install bolts and tighten.
CAUTION: Match the serial numbers on the test frames with the support blocks and lever
arms when assembling multiple testers.
4. Remove or pivot the lever arm safety guards to the side.
5. Check that the knife-edge and V-block mating surfaces are free of dirt or rust.
6. Install the lever arm to the tester with the V-blocks mated to the knife-edges.
NOTE: Take care not to damage knife-edges or proximity switch.
7. Ensure that the lever arm V-blocks are centered on the pedestal block knife-edges front to back.
The lever arm should pivot freely.
8. Install the safety guards and tighten bolts.