6.1
、
Unpacking and Installation
Please dispose of all packaging materials and residues
after unpacking;
Check the equipment. If it is damaged, please keep
wrappers and receipts which must be signed by the carrier
representative (Driver), and contact the carriers to
pursue a claim within 15 days after receiving;
Be sure to install supporting legs before using, and do
not tear up any label or logo before normal using;
Please read these instructions carefully before
installation and operation. Please contact your local
agent if you have any questions;
The equipment shall be installed on a level, solid, non-
skid and incombustible surface, and placed in a well-
lighted work area with waterproof, and away from children
and customers;
The installation position is a well-ventilated place in
accordance with the local regulations;
The charbroiled must be installed under the matched cooking
fume exhauster according to the local regulations;
Important: Installation and ventilation laws, and codes
are very different, you should state and comply with all
codes of the National Fire Protection Association Inc
when it comes to requirements for installation of
equipment;
Screw 4 adjustable stainless steel legs in the tapping
hole with four corners of the charbroiled bottom, ensure
sufficient space for ventilation;
Adjustable stainless steel legs to make the equipment
level, and get the same level with other series of the
same stove; Please lift the equipment rather than drag if
you need to move it;
Supplied gas pressure regulator is factory set at 4”
Natural Gas W.C, and 10”L.P. Gas W.C;
The equipment can only be placed on the incombustible
counter top, and keep a distance of at least 6
inches(152mm) to equipment’s both sides and back, and
keep a distance of at least 4 inches(102mm) to the
bottom;
Do not put anything around the equipment, and on the
counter top and bottom, in order to avoid influencing
combustion and air circulation;
Leave enough distance in front of the equipment to take
apart the control panel. All major parts, in addition to
the burner remove from the front intake-tube;
It may be necessary to adjust the balance of air input by
authorized and licensed technicians;
Thread glue must be resistant to the action of liquefied
petroleum gases.
7