SW5501 – SW5502
Wireless Serial Server
User Manual
Configuration and
setup
you to provide the user, the password, and the certificates
.
Please note that only
*.
pem certificates are
supported
.
Please remember that 2
.
4 GHz frequency can be easily interfered by other wireless devices that operate in the same
spectrum
(
namely, Bluetooth, ZigBee, microwave oven, etc
.)
; therefore, it is better to choose the IEEE 802
.
11a
/
n
which operates in the 5 GHz spectrum when the user
’
s network
allows
.
Steps to Connect to an Access Point
You can manually enter the SSID of the connecting access point in the SSID option or use the
“
scan network
”
button
to have SW550X grab the necessary wireless information of surrounding access points in the device
’
s coverage
area
.
Please be patient as this process might take up to 10 seconds
.
Once it has finished scanning, names and basic properties of available wireless networks will be shown below
.
You
can then
select an AP from the list by clicking on the radio button in
front of the desired SSID
.
Then, click on the
“
Connect
”
button at the bottom of the page and its settings would be loaded automatically to the device
’
s user
interface
(
UI
).
If you would like the scanning process to run again, just click on the
“
Refresh
”
button
.
Otherwise,
click on the
“
Close
”
button to close this window
.
Figure 4.29
Results of network scanning when uses
“
scan network
”
buttons
If no wireless networks have been found, the list would be empty as shown below
.
Figure 4.30
Result when there is no wireless network available in the area
.
